Lesson 5 of 12 · 19 min
Saturation, temperature and solubility curves
Classify solutions as unsaturated, saturated or supersaturated, explain how temperature changes the solubility of solids and gases, and use solubility curves to find crystallising masses and ion concentrations.
What you will be able to do
- Discriminate between unsaturated, saturated and supersaturated solutions.
- Identify how temperature affects the solubility of most solids and of gases.
- Read a solubility curve to find a solubility and classify a solution.
- Calculate the mass of solute that crystallises when a saturated solution cools.
- Calculate the concentration of ions in a saturated solution from solubility data.
Stir sugar into iced tea and the last spoonful sits on the bottom no matter how long you stir. The same spoonful vanishes into hot tea. At any temperature there is a limit to how much solute a given amount of solvent can hold, and that limit usually changes with temperature.
Definition
Three kinds of solution
- An unsaturated solution can dissolve more solute at that temperature.
- A saturated solution holds the maximum amount of solute that can dissolve at that temperature. Add more solid and it stays undissolved.
- A supersaturated solution holds more dissolved solute than a saturated solution at that temperature. It is unstable: a seed crystal, a scratch or a knock makes the excess crystallise until the solution is just saturated.
The solubility of a substance is the amount that makes a saturated solution at a stated temperature, usually in g per 100 g of water.
Solubility curves for six salts, in grams of salt per 100 g of water. A point on a curve is a saturated solution; below it, unsaturated; above it, supersaturated (if no crystals have formed).
Drag the point. Below the curve the solution is unsaturated; on it, saturated. Cool a saturated solution and watch crystals form.
50 g of potassium nitrate is dissolved completely in 100 g of water at 40 °C. Use the solubility curves to classify the solution.
Worked example
Crystals from a cooling solution
A saturated solution of potassium nitrate is made with 50.0 g of water at 60 °C. It is cooled to 20 °C. Use the solubility curve to find the mass of potassium nitrate that crystallises.
Solubility of potassium nitrate, g per 100 g of water.
Step 1: Read the solubility at 60 °C
From the curve, about 110 g of dissolves in 100 g of water at 60 °C.
Step 2: Read the solubility at 20 °C
About 32 g dissolves in 100 g of water at 20 °C.
Step 3: Find the mass crystallising per 100 g of water
per 100 g of water.
The cold water can hold only 32 g; everything above that comes out of solution as crystals.
Step 4: Scale to 50.0 g of water
Try it yourself first, then check the working one step at a time.
Answer
About 39 g of potassium nitrate crystallises.
Method
Read the solubility at each temperature from the curve.
Subtract to get the mass crystallising per 100 g of water.
Scale to the actual mass of water.
Watch out for
Forgetting to halve for 50 g of water, giving 78 g.
Reading the curve at the wrong gridline. Write each reading down.
A saturated solution of potassium chloride in 100 g of water at 80 °C is cooled to 20 °C. Use the curves (solubility at 80 °C: 51.1 g; at 20 °C: 34.0 g per 100 g water) to find the mass of potassium chloride that crystallises.
Note
Supersaturated hand warmers
Reusable hand warmers hold a supersaturated solution of sodium ethanoate. Flexing the metal disc inside starts crystallisation, the excess solute crystallises in seconds, and the energy released warms the pack to about 54 °C. Boiling the pack redissolves the crystals, and it cools slowly back to a supersaturated solution, ready to use again.
Temperature and solubility
For most ionic solids, solubility rises with temperature, a little for sodium chloride and steeply for potassium nitrate. A few solids, such as calcium hydroxide, lithium sulfate and cerium(III) sulfate, become less soluble as the water warms.
Gases become less soluble as water warms. Dissolved gas molecules gain kinetic energy as the water warms, and more of them have enough energy to escape from the surface. That is why a warm soft drink goes flat quickly, and why warm water holds less of the dissolved oxygen fish need.
Solubility of oxygen in fresh water in contact with air at 101.3 kPa. Warm water holds much less oxygen than cold water.
Warm water from a power station's cooling system is released into a river. What happens to the solubility of oxygen in the river water near the outlet?
Concentration of ions from solubility
Solubility data also give the concentration of ions in a saturated solution. Convert the mass that dissolves in a known volume to moles, divide by the volume, then use the dissociation ratio. When the data are per 100 g of water, assume the solution's volume is about 100 mL (and say so): it is only approximate, because dissolving a solid changes the volume.
Worked example
Ion concentrations in saturated solutions
(a) A saturated solution of calcium hydroxide at 20 °C contains 1.73 g of per litre. Calculate the concentration of hydroxide ions in it.
(b) The solubility of potassium chloride at 40 °C is 40.0 g per 100 g of water. Assuming the volume of the saturated solution is 100 mL, estimate , and explain why the estimate is too high.
Step 1: Moles of calcium hydroxide per litre
, so
Step 2: Use the dissociation ratio
, so
Step 3: Moles of potassium chloride in (b)
in 100 g of water.
Step 4: Divide by the assumed volume
, so each formula unit gives one .
Step 5: Evaluate the assumption
Dissolving 40.0 g of solid makes the solution's volume larger than the 100 mL of water, so the true concentration is lower than the estimate.
Try it yourself first, then check the working one step at a time.
Answer
(a) (b) about ; too high, because the solution's volume is more than 100 mL.
Method
Convert the solubility to mol per litre of solution.
Multiply by each ion's coefficient in the dissociation equation.
State any assumption about volume and its effect.
Watch out for
Forgetting the 2 in and giving for hydroxide.
Treating "per 100 g of water" as "per litre".
Common mistake
Scale to the mass of water
Solubility curves are per 100 g of water. For 50 g of water, halve the curve values; for 250 g, multiply by 2.5. And read the curve at the right temperature: write down each reading you take, so the marker can follow your working even if you misread by a gram or two.
Exam tip
Explaining gas solubility
Link temperature to particles: higher temperature, greater average kinetic energy, more dissolved gas molecules with enough energy to escape, lower solubility. Then link to the context (fish, soft drinks, thermal pollution).
Summary
Unsaturated: can dissolve more. Saturated: the maximum at that temperature. Supersaturated: more than the maximum, and unstable.
On a solubility curve, points below are unsaturated, points on the curve are saturated, and points above are supersaturated.
Most solids are more soluble in hot water; gases are less soluble in hot water.
Mass crystallising on cooling solubility at the high temperature solubility at the low temperature, scaled to the mass of water.
Ion concentrations in a saturated solution come from the solubility in mol per litre and the dissociation ratio.
Finished the lesson?
Try the 3 quick checks above and the lesson completes itself, or mark it complete now.