Lesson 12 of 12 · 20 min

Blood, water quality and water treatment

See blood plasma as an aqueous solution, explore why blood is red and how blood types work, then evaluate a waterway's quality from its measurements and follow how drinking water is treated.

What you will be able to do

  • Describe blood plasma as an aqueous solution of ionic and molecular substances.
  • Explain why blood is red, and the chemistry that distinguishes the ABO blood types.
  • Explain how the composition of water from different sources affects its treatment and use.
  • Evaluate water quality from measurements of pH, dissolved oxygen, turbidity, conductivity and other properties.
  • Describe the steps that turn raw water into safe drinking water.

About 55 % of your blood is plasma, a pale yellow liquid that is roughly 92 % water. Everything in this topic applies to it: dissolved ions at concentrations measured in  mmol L−1\unit{mmol\,L^{-1}}, polar molecules dissolved by hydrogen bonding, gases whose solubility depends on temperature, and a pH held between 7.35 and 7.45.

Typical concentrations in the blood plasma of a healthy adult (1 mmol L−1=10−3 mol L−11\unit{mmol\,L^{-1}} = 10^{-3}\unit{mol\,L^{-1}}).
SubstanceTypeTypical concentration
sodium ions, NaX+\ce{Na+}ionic135–145  mmol L−1\unit{mmol\,L^{-1}}
chloride ions, ClX−\ce{Cl-}ionic95–110  mmol L−1\unit{mmol\,L^{-1}}
hydrogen carbonate ions, HCOX3X−\ce{HCO3-}ionic22–29  mmol L−1\unit{mmol\,L^{-1}}
potassium ions, KX+\ce{K+}ionic3.5–5.0  mmol L−1\unit{mmol\,L^{-1}}
calcium ions, CaX2+\ce{Ca^2+}ionic2.1–2.6  mmol L−1\unit{mmol\,L^{-1}}
glucose, CX6HX12OX6\ce{C6H12O6}molecular3.5–6.0  mmol L−1\unit{mmol\,L^{-1}} (fasting)
urea, CO(NHX2)X2\ce{CO(NH2)2}molecular2.5–7.5  mmol L−1\unit{mmol\,L^{-1}}
proteins such as albuminmolecular (large)60–80  g L−1\unit{g\,L^{-1}} in total
dissolved OX2\ce{O2} and COX2\ce{CO2}molecularsmall; most OX2\ce{O2} is carried by haemoglobin

Worked example

Is saline the same as blood plasma?

  • Complex familiar
  • Technology active

"Normal saline" for intravenous drips is 0.90 % (w/v) sodium chloride: 0.90 g of NaCl\ce{NaCl} in every 100 mL of solution.

(a) Calculate [NaCl][\ce{NaCl}] in  mol L−1\unit{mol\,L^{-1}}, and [NaX+][\ce{Na+}] and [ClX−][\ce{Cl-}] in  mmol L−1\unit{mmol\,L^{-1}}.

(b) Compare these with typical plasma values ([NaX+][\ce{Na+}] 135–145 and [ClX−][\ce{Cl-}] 95–110  mmol L−1\unit{mmol\,L^{-1}}).

4 steps

Try it yourself first, then check the working one step at a time.

Method

  1. Convert a percentage (w/v) to g per litre, then to mol per litre.

  2. Use the dissociation ratio for each ion.

  3. Convert mol to mmol by multiplying by 1000.

Watch out for

  • Treating 0.90 % as 0.90 g per litre.

Select all the substances in blood plasma that are dissolved as molecules rather than as ions.

Select all that apply.

Why blood is red

Red blood cells are packed with haemoglobin, a protein with four haem groups. Each haem has an iron(II) ion, FeX2+\ce{Fe^2+}, held at the centre of a flat ring of carbon and nitrogen atoms (a porphyrin), with its four nitrogen atoms bonded to the iron. An oxygen molecule binds to each iron(II) ion, so one haemoglobin carries up to four OX2\ce{O2} molecules.

The haem group absorbs blue-green light strongly and lets red light through, so blood looks red. Oxygen-rich blood in arteries (oxyhaemoglobin) is bright scarlet; oxygen-poor blood in veins is a darker red, not blue. Veins only look blue through the skin. Carbon monoxide is dangerous because it binds to the same iron about 200 times more strongly than oxygen does, so haemoglobin can no longer carry oxygen.

The chemistry of blood types

The surface of every red blood cell carries short chains of sugar molecules (antigens) attached to its membrane proteins and lipids. Every person has the base chain, called the H antigen. Your ABO type depends on which extra sugar, if any, an enzyme adds to the end of it:

  • Type A: N-acetylgalactosamine is added (A antigen).
  • Type B: galactose is added (B antigen).
  • Type AB: both are present on different chains.
  • Type O: neither is added; only the H antigen is present.

Plasma contains antibodies against the antigens your own cells lack: type A plasma has anti-B, type B has anti-A, type O has both and type AB has neither. If donated red cells carry an antigen the recipient's antibodies recognise, the cells clump together (agglutinate), which can be fatal. The separate Rh (D) antigen, a membrane protein, gives the positive or negative sign. That is why O negative red cells can be given to almost anyone in an emergency.

A patient has blood type B. Which antibodies are in their plasma, and why can they not receive type A red blood cells?

Choose one answer

Water from different sources

What is dissolved in water depends on where it has been, and that decides how it must be treated and what it can be used for.

  • Rainwater has very few dissolved solids and is slightly acidic (dissolved COX2\ce{CO2}), but it picks up dust, leaves and bacteria from roofs and tanks.
  • Rivers and dams carry suspended clay (turbidity), organic matter that colours the water, nutrients, and microorganisms from animals and sewage.
  • Groundwater (bores) is usually clear, but it has dissolved minerals from rock: often hard water rich in CaX2+\ce{Ca^2+}, MgX2+\ce{Mg^2+} and HCOX3X−\ce{HCO3-}, sometimes iron or salt. It may be fine for stock but too salty for irrigation or drinking.
  • Seawater holds about 35 g L−135\unit{g\,L^{-1}} of dissolved salts, mostly sodium chloride, and must be desalinated before people can drink it.
Measurable properties used to judge water quality. Guideline values are from the Australian Drinking Water Guidelines (drinking) or are typical healthy ranges for freshwater ecosystems.
PropertyWhat it showsTypical target
pHacid or alkali pollution; acid mine drainage; algal activity6.5–8.5 for drinking; about 6.5–8.0 for most freshwater life
dissolved oxygen (DO)whether fish and other animals can breathe; low DO signals decaying organic matter or warm waterabove about 6 mg L−16\unit{mg\,L^{-1}} (roughly 80–110 % saturation)
turbiditysuspended sediment, which blocks light and shelters microbes from disinfectionbelow 5 NTU for drinking, ideally below 1 NTU before disinfection
electrical conductivity / total dissolved solidssalinity: dissolved ions from rock, seawater or runoffTDS below about 600 mg L−1600\unit{mg\,L^{-1}} tastes good
nitrate and phosphatefertiliser or sewage runoff; can cause algal blooms (eutrophication)as low as possible in waterways
temperatureaffects how much oxygen dissolves; thermal pollutionclose to the natural range for the waterway
E. colicontamination by faeces, and so by disease-causing microbesnone detected in 100 mL of drinking water

Worked example

Evaluating the health of a creek

  • Complex unfamiliar
  • Technology free

A Year 11 class sampled a suburban creek at 2 pm, two days after heavy rain. Their results: water temperature 26 °C, pH 6.1, dissolved oxygen 3.8 mg L−13.8\unit{mg\,L^{-1}}, turbidity 45 NTU, electrical conductivity 420 μS cm−1420\unit{\mu S\,cm^{-1}} (normal for this creek). At 26 °C, water saturated with air holds about 8.1 mg L−18.1\unit{mg\,L^{-1}} of oxygen.

Evaluate the water quality of the creek for aquatic life, and suggest what further data would make the evaluation more reliable.

6 steps

Try it yourself first, then check the working one step at a time.

Method

  1. Compare each measurement with a guideline or healthy range.

  2. Explain what each comparison suggests, and its likely cause.

  3. Make an overall judgement, then evaluate the reliability of the data.

Watch out for

  • Listing the numbers without comparing them to anything.

  • Making a judgement from one measurement and ignoring the others.

The main stages of conventional drinking-water treatment.

Treating water for drinking

  1. Screening removes sticks, leaves and fish.
  2. Coagulation and flocculation: alum (aluminium sulfate) is added. Its aluminium ions form a sticky precipitate of aluminium hydroxide, AlX3+(aq)+3 OHX−(aq)→Al(OH)X3(s)\ce{Al^3+(aq) + 3OH-(aq) -> Al(OH)3(s)}, which traps fine clay and organic particles in clumps called floc.
  3. Sedimentation: the floc settles to the bottom of large tanks.
  4. Filtration through sand and gravel (sometimes activated carbon or membranes) removes the remaining particles and some microbes.
  5. Disinfection kills bacteria and viruses, usually with chlorine, which forms hypochlorous acid in water: ClX2(g)+HX2O(l)⇌HOCl(aq)+HCl(aq)\ce{Cl2(g) + H2O(l) <=> HOCl(aq) + HCl(aq)}. Ultraviolet light and ozone are alternatives.
  6. pH adjustment with lime (calcium hydroxide) stops the water corroding pipes, and fluoride is added to protect teeth.

Where fresh water is scarce, seawater or bore water is desalinated by reverse osmosis, pushing it through membranes that let water molecules through but not the ions, as at the Gold Coast Desalination Plant. South-east Queensland can also purify treated wastewater to drinking standard.

What is the purpose of adding alum at a water treatment plant?

Choose one answer

Exam tip

Evaluating water quality

For each measurement: state it, compare it with the guideline or a healthy range, say what the comparison suggests about the waterway (and possible causes), and then make an overall judgement. Mention limitations: a single sample on one day, the time of day for DO and temperature, and which properties were not measured (such as E. coli).

Summary

  • Blood plasma is about 92 % water, with ions (NaX+\ce{Na+}, ClX−\ce{Cl-}, HCOX3X−\ce{HCO3-}, KX+\ce{K+}, CaX2+\ce{Ca^2+}) and molecules (glucose, urea, proteins) dissolved in it.

  • Blood is red because the iron(II)-containing haem groups of haemoglobin absorb blue-green light.

  • ABO blood types depend on which sugar antigens sit on the red cells; plasma has antibodies against the antigens a person lacks.

  • The composition of water from rain, rivers, bores or the sea decides how it is treated and used.

  • Water quality is judged from pH, dissolved oxygen, turbidity, conductivity, nutrients, temperature and E. coli, each compared with guideline values.

  • Drinking water is screened, coagulated with alum, settled, filtered, disinfected with chlorine and pH-adjusted.

Finished the lesson?

Try the 3 quick checks above and the lesson completes itself, or mark it complete now.

Lesson 12 of 120% read

Save your progress with a free account