Lesson 9 of 12 · 19 min
Electromagnetic induction: Faraday's and Lenz's laws
Explain electromagnetic induction, calculate induced EMF with , and use Lenz's law and conservation of energy to find the direction of induced currents.
What you will be able to do
- Describe electromagnetic induction, EMF, Faraday's law and Lenz's law.
- Calculate the induced EMF from a change in flux with .
- Use Lenz's law to find the direction of an induced current.
- Explain how Lenz's law follows from the conservation of energy.
In 1831 Michael Faraday wound two separate coils of wire onto an iron ring. A steady current in the first coil did nothing to the second. But at the instant he switched the current on or off, a needle connected to the second coil kicked. A changing magnetic field had made a current.
Within months Faraday had built the first electric generator. Almost all of the world's electricity is still made by the effect he discovered.
Note
Investigate: a magnet and a coil
Connect a coil to a galvanometer (a sensitive ammeter with its zero in the middle) and move a bar magnet in and out of the coil. You will find that:
- the needle moves only while the magnet or the coil is moving
- it deflects one way as the magnet goes in and the other way as it comes out, and the directions swap if you turn the magnet around
- faster motion, a stronger magnet or a coil with more turns gives a bigger deflection
- a magnet held still inside the coil, however strong, gives no reading at all.
Push the magnet in quickly, then slowly, then hold it still inside the coil. When does the meter move, and which way?
Definition
Induction and EMF
Electromagnetic induction is the production of an EMF in a conductor by changing the magnetic flux through it.
EMF (electromotive force) is the energy a source gives each coulomb of charge, measured in volts. Despite the name it is not a force. An induced EMF drives a current if the circuit is complete.
Key idea
Faraday's law
The EMF induced in a coil is proportional to the rate of change of the magnetic flux through it, multiplied by the number of turns.
Since , there are three ways to change the flux through a coil:
- change the field : move a magnet, or switch a current in a nearby coil on or off
- change the area : slide a rod along rails, or squash the loop
- change the angle: rotate the coil, as in a generator.
The faster the change, the larger the EMF. Each turn has the same EMF induced in it, and the turns are in series, so the EMFs add: that is the factor .
The flux through each turn of an 80-turn coil changes by in . Calculate the size of the average induced EMF.
Worked example
EMF from a changing magnetic field
A coil of 200 turns, each of area , sits with its plane perpendicular to a magnetic field. The field increases steadily from to in .
(a) Calculate the size of the average induced EMF.
(b) The coil is part of a circuit with a total resistance of . Calculate the induced current.
Step 1: Find the change in flux through one turn
The plane is perpendicular to the field, so and .
Step 2: Apply Faraday's law
Each turn has the same EMF induced in it, and the turns are in series, so the EMFs add: that is the factor .
Step 3: Find the current
Try it yourself first, then check the working one step at a time.
Answer
(a) (b)
Method
Find the change in flux, .
Use ; the minus sign only tells you the direction (Lenz's law).
Use for the current.
Watch out for
Using the final field () instead of the change in field.
Leaving out .
Flux through each turn of a 50-turn coil. The induced EMF depends on the gradient of this graph.
Use the graph above. Calculate the size of the EMF induced in the 50-turn coil between and .
Key idea
Lenz's law
An induced current always flows in the direction that opposes the change in flux that produced it. This is the meaning of the minus sign in Faraday's law.
Finding the direction of an induced current
Look at the external flux
Which way does the external field point through the coil, and is the flux increasing or decreasing?
Oppose the change
If the flux is increasing, the induced field points the opposite way. If it is decreasing, the induced field points the same way, to prop it up.
Turn the field into a current
Use the right-hand grip rule to find the direction of current that makes that induced field.
Worked example
Direction of an induced current
The north pole of a bar magnet is pushed towards the left-hand end of a coil connected to a galvanometer.
(a) Which way does the induced current flow around the coil, as seen by someone looking at its left-hand end from the magnet's side?
(b) Explain why work must be done to push the magnet in.
Step 1: Identify the change in flux
Field lines leave a north pole, so inside the coil the magnet's field points to the right, away from the magnet. As the magnet approaches, this flux increases.
Step 2: Apply Lenz's law
The induced current must oppose the increase, so its own field inside the coil points to the left, back towards the magnet.
Lenz's law says the induced current opposes the change in flux, not the flux itself.
Step 3: Use the right-hand grip rule
A coil whose field points out of its left end (towards the viewer) has that end as a north pole. Curl your right fingers so your thumb points towards you, and they show the current running anticlockwise as you look at the left end.
Step 4: Explain the work done
The coil's left end is a north pole facing the magnet's north pole, so they repel. You must push against this repulsion, and the work you do becomes the electrical energy of the induced current (which heats the circuit). If the current flowed the other way, the coil would pull the magnet in, giving it kinetic energy and electrical energy from nothing, which would break the conservation of energy.
Try it yourself first, then check the working one step at a time.
Answer
(a) Anticlockwise, as seen from the magnet's side: that end of the coil becomes a north pole. (b) The coil repels the approaching magnet, so work must be done against the repulsion; that work supplies the electrical energy, as conservation of energy requires.
Method
Which way does the external flux point, and is it increasing or decreasing?
The induced field opposes the change.
Turn the induced field into a current direction with the right-hand grip rule.
Watch out for
Making the induced field oppose the magnet's field even when the flux is decreasing. Then the induced field points the same way as the magnet's field.
The north pole of a bar magnet is pulled away from one end of a coil connected to a galvanometer. What does the end of the coil nearest the magnet become while the magnet moves away?
Key idea
Lenz's law and the conservation of energy
Suppose the induced current flowed the other way, so that a coil attracted an approaching magnet. The magnet would speed up, the flux would change faster, the current would grow, the attraction would get stronger, and so on: kinetic energy and electrical energy would grow from nothing. That would break the law of conservation of energy.
Instead, the induced current always opposes the change, so you must do work against a magnetic force to keep the change going. That work is the source of the electrical energy, which ends up as heat in the circuit. Lenz's law is conservation of energy applied to induction.
History
Faraday and Lenz
Michael Faraday (1791–1867) had little formal schooling and almost no mathematical training, so he described his discoveries in pictures: "lines of force", the field lines you draw today. Emil Lenz (1804–1865), working in St Petersburg, stated the rule for the direction of induced currents in 1834. It was James Clerk Maxwell who later turned Faraday's lines of force into mathematics.
Exam tip
Explaining induction
"Explain" questions on induction reward a clear chain of cause and effect: the magnet moves, so the flux through the coil changes; by Faraday's law an EMF is induced; the circuit is complete, so a current flows; by Lenz's law its field opposes the change. Name each law at the step where you use it.
Summary
An EMF is induced in a conductor whenever the magnetic flux through it changes; a steady flux, however large, induces nothing.
Faraday's law: . The EMF depends on the rate of change of flux and the number of turns.
The flux can change through , the area or the angle: .
Lenz's law: the induced current opposes the change in flux that caused it.
Lenz's law is required by conservation of energy. The work done against the opposing force becomes electrical energy.
Finished the lesson?
Try the 3 quick checks above and the lesson completes itself, or mark it complete now.