Lesson 5 of 10 · 15 min

Capture–recapture and the Lincoln index

Estimate the size of an animal population with the Lincoln index, N=M×nmN = \frac{M \times n}{m}, rearrange it, and judge how its assumptions and small samples affect the estimate.

What you will be able to do

  • Describe the capture–recapture technique.
  • Use the Lincoln index N=M×nmN = \frac{M \times n}{m} to estimate population size, and rearrange it to find MM, nn or mm.
  • State the assumptions of the Lincoln index and predict whether breaking each one makes the estimate too high or too low.
  • Explain why small recapture numbers make an estimate uncertain.

You can't put quadrats over animals that run, swim or fly away. To estimate how many there are, ecologists catch some, mark them harmlessly, let them go, and come back later for a second catch. If a quarter of the second catch carries a mark, then about a quarter of the whole population was marked the first time. Since you know how many you marked, you can work out the whole.

Capture–recapture

  1. Capture a first sample

    Trap or net animals across the site, using the same method everywhere.

  2. Mark and release them

    Use a mark that lasts, doesn't harm the animal and doesn't change its behaviour or its chance of being eaten: a dab of non-toxic paint on a beetle's wing case, a fin clip, a microchip, a numbered ear tag. Record the number marked, MM.

  3. Allow time to mix

    Leave long enough for marked animals to mix back through the population, but not so long that many are born, die or move in or out.

  4. Capture a second sample

    Use the same method. Count the total caught, nn, and the number of those that are marked, mm.

Key idea

The Lincoln index

The fraction marked in the second sample estimates the fraction marked in the whole population:

mn=MN⟹N=M×nm\frac{m}{n} = \frac{M}{N} \qquad\Longrightarrow\qquad N = \frac{M \times n}{m}
  • NN: estimated population size
  • MM: number caught and marked in the first sample
  • nn: total number caught in the second sample
  • mm: number of marked animals in the second sample

Because m≤nm \le n, the estimate NN is never smaller than nn, and never smaller than MM.

Worked example

Estimate a skink population with the Lincoln index

  • Simple familiar
  • Technology active

Students catch 35 garden skinks in a schoolyard garden, mark each with a small dot of non-toxic paint and release them. Three days later they catch 42 skinks, 7 of which have paint dots. Estimate the population of skinks in the garden.

4 steps

Try it yourself first, then check the working one step at a time.

Method

  1. Label MM, nn and mm from the question.

  2. Substitute into N=M×nmN = \frac{M \times n}{m}.

  3. Check: N≥nN \ge n and N≥MN \ge M.

Watch out for

  • Calculating M×mn=5.8\frac{M \times m}{n} = 5.8: an estimate smaller than the samples is impossible.

In a farm dam, 48 freshwater crayfish (yabbies) are caught, tagged and released. A week later 60 are caught, and 15 of them are tagged. Estimate the population of yabbies in the dam.

in yabbies
Interactive

Mark and recapture

Run capture–recapture on a population you can't see. Repeat it a few times with small and then large samples: how much do the estimates vary?

The assumptions

The Lincoln index only gives a fair estimate if the second sample really is a fair mix of marked and unmarked animals. That needs several assumptions.

Assumptions of the Lincoln index, and what happens to the estimate when each is broken.
AssumptionIf it is broken…Effect on NN
The population is closed: no births, deaths, immigration or emigration between the samples.Unmarked animals born or moving in dilute the marked ones, so mm is smaller than it should be.Too high (relative to the population when marking was done)
Marks are not lost (paint not worn off, tags not shed).Marked animals are counted as unmarked, so mm is too small.Too high
Marking does not affect survival (bright paint doesn't attract predators).Marked animals die faster, so fewer are recaptured.Too high
Marked animals are no more or less likely to be caught again.If marked animals avoid traps ("trap-shy"), mm is too small; if they return for the bait ("trap-happy"), mm is too large.Too high if trap-shy; too low if trap-happy
Marked animals have had time to mix evenly through the population.If they are still near the release point and the second sample is taken there, mm is too large.Usually too low

Some of the paint marks on a sample of beetles wear off before the second capture. What effect does this have on the Lincoln index estimate?

Choose one answer

Key idea

Small samples, big uncertainty

The estimate is very sensitive to mm when mm is small. With M=20M = 20 and n=20n = 20:

mm2345
NN20013310080

Going from m=2m = 2 to m=3m = 3, one extra marked animal cuts the estimate by a third. Large samples (and so a larger mm) and repeated estimates give a more reliable result. Report the mean of repeated estimates and their range.

Worked example

Evaluate repeated capture–recapture estimates

  • Complex unfamiliar
  • Technology active

Bush rats (Rattus fuscipes) in a 4 ha patch of forest were sampled with Elliott traps three times, a month apart. Each time, 30 rats were caught and marked with a fur clip in the first night, and the traps were reopened two nights later.

TrialMMnnmm
130286
230328
330253

(a) Calculate the population estimate for each trial and the mean. (b) Identify the least reliable estimate and explain why. (c) Fur clips grow out over several weeks. Explain whether this affects these results. (d) Suggest one improvement.

5 steps

Try it yourself first, then check the working one step at a time.

Method

  1. Calculate each estimate before averaging.

  2. Look for an anomaly and explain it from the data (small mm, an assumption broken).

  3. Judge each assumption against the timing and method given.

  4. Suggest an improvement that targets the specific weakness.

Watch out for

  • Dropping an anomalous result without giving a reason.

  • Saying "do more trials" without saying how it improves reliability.

Rangers estimate that a creek holds about 400 Mary River turtles. They plan to mark 80 turtles, and then catch 50 in a second sample. If their estimate is right, how many of the 50 should be marked?

in turtles

Common mistake

Mixing up the letters

MM (marked first time) and mm (marked in the second sample) differ only in case. Write them out in words before you substitute. A check: NN must be at least as large as both MM and nn. If it isn't, you have nn and mm swapped.

Summary

  • Capture, mark and release MM animals; later catch nn, of which mm are marked.

  • N=M×nmN = \dfrac{M \times n}{m}, because the fraction marked in the second sample estimates the fraction marked in the population.

  • Assumptions: a closed population, marks not lost, marks don't affect survival or catchability, and time to mix.

  • Anything that makes mm too small (lost marks, deaths of marked animals, unmarked immigrants, trap-shy animals) makes NN too high.

  • Small mm makes the estimate very uncertain; larger samples and repeats improve reliability.

Finished the lesson?

Try the 3 quick checks above and the lesson completes itself, or mark it complete now.

Lesson 5 of 100% read

Save your progress with a free account