Lesson 8 of 10 · 18 min

Classifying ecosystems with Specht and Holdridge

Classify and name Australian vegetation from the height, life form and foliage projective cover of its tallest stratum (Specht), and place an ecosystem in a Holdridge life zone from climate data.

What you will be able to do

  • Explain how foliage projective cover (FPC) and the life form and height of the tallest stratum are measured.
  • Use Specht's structural classification to name a vegetation formation from field data.
  • Use biotemperature, annual precipitation and the potential evapotranspiration ratio to place a site in a Holdridge life zone.
  • Explain how classifying ecosystems, helped by computing, supports ecosystem management.

"Bush" can mean a rainforest, a eucalypt forest, a spinifex plain or a coastal heath. Land managers, scientists and planners need names that mean the same thing to everyone, so a map can say which vegetation lies where and a report can compare a site with others of the same kind. In Australia two schemes are used in this course: Specht's structural classification, from what the vegetation looks like on the ground, and the Holdridge life zone scheme, from climate.

Definition

Foliage projective cover

Foliage projective cover (FPC) is the percentage of the ground that would be shaded by the foliage of a stratum if the sun were directly overhead. It counts leaves only (not branches or gaps inside crowns), so it is lower than the crown cover. It is measured by sighting straight up through a tube or densitometer at points along a transect and recording whether foliage is hit, or estimated from aerial and satellite images.

Field data sometimes give canopy (crown) cover instead, measured by the line-intercept method: add up the lengths of a tape that lie under tree crowns and divide by the tape's length. Data tests may ask you to use it as an estimate of foliage cover; remember that it slightly overestimates FPC, which matters only when the value is close to a class boundary.

Specht's structural classification

Raymond Specht's system (first published in 1970, and still the basis of vegetation mapping in Australia) names a formation from two features of the tallest stratum (the uppermost layer of the vegetation):

  1. its life form and height: trees (single trunk) or shrubs (several stems), hummock grasses, or herbs;
  2. its foliage projective cover.
Specht's structural formations (after Specht 1970). Read across from the life form and height of the tallest stratum to its FPC.
Life form and height of tallest stratumFPC 70–100 %FPC 30–70 %FPC 10–30 %FPC < 10 %
Trees > 30 mTall closed forestTall open forestTall woodlandTall open woodland
Trees 10–30 mClosed forestOpen forestWoodlandOpen woodland
Trees 5–10 mLow closed forestLow open forestLow woodlandLow open woodland
Shrubs 2–8 mClosed scrubOpen scrubTall shrublandTall open shrubland
Mallee (multi-stemmed eucalypts) 2–8 m—Mid-dense malleeMalleeOpen mallee
Shrubs 0–2 mClosed heathOpen heathLow shrublandLow open shrubland
Hummock grasses 0–2 m——Hummock grasslandOpen hummock grassland
HerbsClosed herblandHerblandOpen herbland—

Note

Reading the table

  • Trees are single-stemmed; shrubs and mallee are multi-stemmed. Height boundaries: trees taller than 30 m are "tall", 10–30 m (both included) the middle row, and 5 to under 10 m "low"; shrubs of 2 m and under are the low row.
  • Grasses, sedges and ferns follow the herb row's pattern with their own word: closed tussock grassland, tussock grassland, open tussock grassland; closed sedgeland, sedgeland, open sedgeland; and so on.
  • Specht printed the names with hyphens (open-forest, closed-heath); either way is accepted. A "—" is a combination the table leaves empty.

Classifying a site with Specht's system

  1. Sample the site by strata

    Identify the layers (tallest trees, lower trees, shrubs, ground layer) and record the life form, height and FPC of each.

  2. Find the tallest stratum

    Only the uppermost layer is used, even if a lower layer is denser.

  3. Choose the row

    From its life form and height: a clinometer or a measuring pole gives tree height.

  4. Choose the column

    From its FPC.

  5. Name the formation

    Read the name, and add the dominant species if known: "spotted gum open forest".

A stratified survey of a site west of Toowoomba records three strata: trees 18 m tall with an FPC of 22 %; shrubs 3 m tall with an FPC of 35 %; and a grass layer with an FPC of 60 %. Use Specht's classification to name the formation.

Interactive

Specht's formations

Read the stratified field data, set the tallest stratum's life form, height and FPC, and name the formation. Then try the heath and woodland sites.

Worked example

Classify a site from stratified field data

  • Complex familiar

A stratified survey of a site near Gympie recorded four strata. The FPC of the tallest stratum was measured by sighting upwards through a tube at 100 points, 1 m apart, along a transect: foliage was hit at 46 points.

StratumLife formHeight range (m)FPC (%)
1Trees (spotted gum, ironbark)24–28see above
2Small trees (wattles)8–1215
3Shrubs1–310
4Grasses and herbsbelow 170

Calculate the FPC of the tallest stratum and use Specht's classification to name the formation.

4 steps

Try it yourself first, then check the working one step at a time.

Method

  1. FPC from point-intercept: hits ÷ points × 100.

  2. Use only the tallest stratum's life form, height and FPC.

  3. Read the formation from the row (life form and height) and column (FPC).

Watch out for

  • Using the 70 % grass cover and calling it closed forest.

  • Calling it tall open forest: the trees are under 30 m.

The Holdridge life zones

Specht's system describes vegetation you can see. The Holdridge life zone scheme, devised by the American botanist Leslie Holdridge in 1947 and refined in 1967, predicts what vegetation a climate should support, anywhere on Earth. It uses three climate measures, plotted on logarithmic axes that form a grid of hexagons, each a life zone.

Key idea

Holdridge's three measures

  • Biotemperature: the mean annual temperature, counting any temperature below 0 °C0\unit{°C} (and, in Holdridge's later version, above 30 °C30\unit{°C}) as 0 °C0\unit{°C}, because plants barely grow outside that range. It sets the latitudinal region (polar, subpolar, boreal, cool temperate, warm temperate, subtropical, tropical) or the matching altitudinal belt on a mountain.
  • Mean annual precipitation, in mm.
  • Potential evapotranspiration (PET) ratio: the water that vegetation could lose in a year, divided by the precipitation. Holdridge estimated PET (in mm) as 58.93×58.93 \times biotemperature. A ratio above 1 means the climate can evaporate more water than falls (subhumid, then semi-arid through to superarid); below 1 means a surplus (humid, perhumid, superhumid). It sets the humidity province.

The life zone combines them: for example subtropical moist forest, tropical dry forest, warm temperate desert scrub.

Holdridge life zones by latitudinal region (biotemperature) and annual precipitation. Below 1.5 °C is polar desert; from 1.5 to 3 °C (subpolar) the zones are dry, moist, wet and rain tundra for 62.5–125, 125–250, 250–500 and 500–1000 mm. A "—" is outside the chart.
Precipitation (mm)Boreal 3–6 °CCool temperate 6–12 °CWarm temperate 12–17 °CSubtropical 17–24 °CTropical 24–30 °C
62.5–125desertdesertdesertdesertdesert
125–250dry scrubdesert scrubdesert scrubdesert scrubdesert scrub
250–500moist foreststeppethorn scrubthorn woodlandthorn woodland
500–1000wet forestmoist forestdry forestdry forestvery dry forest
1000–2000rain forestwet forestmoist forestmoist forestdry forest
2000–4000—rain forestwet forestwet forestmoist forest
4000–8000——rain forestrain forestwet forest
8000–16 000————rain forest

Note

Reading the Holdridge table

  • The frost line (critical temperature line) between warm temperate and subtropical lies at a biotemperature of about 16–18 °C; this course uses 17 °C. On a mountain, the same bands are altitudinal belts (montane, lower montane, premontane and so on).
  • The PET ratio bands, from wet to dry: superhumid 0.125–0.25, perhumid 0.25–0.5, humid 0.5–1, subhumid 1–2, semi-arid 2–4, arid 4–8, perarid 8–16, superarid 16–32. Each life zone sits in one province: subtropical moist forest is humid, tropical dry forest subhumid.
  • On Holdridge's chart each life zone is a hexagon, so a site very close to a boundary is placed by where its point falls on the chart. Well inside a band, the table and the chart agree.

Worked example

Place a site in a Holdridge life zone

  • Complex familiar
  • Technology active

A site in the hinterland of south-east Queensland has monthly mean temperatures from 15 °C15\unit{°C} to 26 °C26\unit{°C}, a mean annual temperature of 20.5 °C20.5\unit{°C} and a mean annual rainfall of 1500 mm1500\unit{mm}.

(a) State its biotemperature. (b) Calculate its potential evapotranspiration and PET ratio. (c) Use the Holdridge scheme to name its life zone.

4 steps

Try it yourself first, then check the working one step at a time.

Method

  1. Biotemperature: the mean with any temperature below 0 °C (or above 30 °C) counted as 0.

  2. PET =58.93×= 58.93 \times biotemperature; PET ratio == PET ÷ precipitation.

  3. Read the latitudinal region from biotemperature and the humidity province from the PET ratio and rainfall.

Watch out for

  • Dividing precipitation by PET: the ratio is PET over precipitation.

Interactive

Holdridge life zones

Move from Brisbane to Cairns, Alice Springs and Hobart. Which measure changes most from Brisbane to Alice Springs, and which from Brisbane to Hobart?

Note

Why the global pattern looks the way it does

Temperature falls from the equator to the poles and with altitude, and rainfall depends on air circulation, ocean currents and mountains. Holdridge's scheme shows that these two factors, through biotemperature and the PET ratio, explain much of the global distribution of ecosystems: rainforests where it is warm and wet, deserts where evaporation far exceeds rain, tundra where it is too cold for trees. Soils, fire and human land use explain much of the rest.

Classification, computing and management

Classifying ecosystems is not an end in itself. Queensland's regional ecosystem framework, maintained by the Queensland Herbarium, classifies vegetation by bioregion, land zone (geology and landform) and plant community, and maps it across the state. Each regional ecosystem is given a status under the Vegetation Management Act 1999 (endangered, of concern or least concern), which decides whether and how it may be cleared. Classifying first makes it possible to protect the rarest ecosystems, plan fire regimes for each type and report change.

This depends on computing. Satellite images of the whole state are analysed each year (Queensland's Statewide Landcover and Trees Study has tracked clearing of woody vegetation from Landsat imagery since the late 1980s). Software combines those images with climate, soil and species records to classify regions from very large biotic and abiotic data sets and to compare them over time, which no team working by hand could do.

Which is the best reason for classifying and mapping the vegetation of a region before deciding where clearing may be allowed?

Choose one answer

Common mistake

Classification slips

  • Using the densest stratum, or the ground layer, instead of the tallest stratum in Specht's system.
  • Using crown cover instead of foliage projective cover: FPC leaves out gaps between leaves, so it is lower.
  • Writing "forest" for any trees: below 30 % FPC, trees form woodland, not forest.
  • In Holdridge, using the plain mean temperature when some months are below 0 °C0\unit{°C}; biotemperature counts those as zero.

Summary

  • Specht's system names a formation from the life form and height of the tallest stratum and its foliage projective cover.

  • FPC is the percentage of ground shaded by foliage with the sun overhead; it is measured along transects or from images.

  • Holdridge's scheme classifies life zones from biotemperature, annual precipitation and the PET ratio (PET=58.93×\text{PET} = 58.93 \times biotemperature).

  • Temperature and the balance of rainfall and evaporation explain much of the global distribution of ecosystems.

  • Classification, supported by satellite data and computing, lets managers map ecosystems, protect rare ones and track change over time.

Finished the lesson?

Try the 2 quick checks above and the lesson completes itself, or mark it complete now.

Lesson 8 of 100% read

Save your progress with a free account