Lesson 2: Separating mixtures
Separating iron, salt and sand
SkillSeparating mixtures
Worked example
A mixture contains iron filings, sand and salt (sodium chloride). Describe how to obtain a dry sample of each, naming the property each step relies on.
Step 1: List the differences in properties
Iron is magnetic; sand and salt are not. Salt dissolves in water; sand and iron do not.
Every separation step uses one difference. Listing them first shows you the order.
Step 2: Remove the iron first
Spread the dry mixture out and pass a magnet (wrapped in plastic, so the filings slide off easily) over it. The iron filings are attracted to the magnet and lifted out.
Do this while the mixture is dry. In water the iron would begin to rust, and wet sand and salt would stick to it.
Step 3: Dissolve the salt
Add warm water to the sand and salt and stir until the salt has dissolved.
Step 4: Filter
Filter the mixture. The sand stays on the filter paper (insoluble, too large to pass through); the salt solution passes through as the filtrate. Wash the sand with a little water.
Step 5: Crystallise the salt and dry the sand
Evaporate most of the water from the filtrate, then leave it to crystallise. Dry the sand in a warm oven.
Answer
(1) Magnet: removes the magnetic iron. (2) Dissolve in water: the salt is soluble, the sand is not. (3) Filter: separates insoluble sand from the salt solution. (4) Evaporate and crystallise: recovers the salt, because the water is volatile and the salt is not. Dry each product.
Try a similar one
A fresh question of the same kind, checked as you answer, with hints and a full solution.
Method
List the properties in which the components differ.
Remove whatever is easiest to remove from the dry mixture first.
Dissolve, filter, then evaporate or crystallise.
Name the property each step uses.
Watch out for
Adding water first, so the iron rusts and the magnet picks up wet sand.
Saying filtration separates the salt: dissolved salt goes through the paper.