Lesson 10: Circuits for real-life purposes
Choosing a resistor for an LED
SkillsCircuits for real-life purposesSeries circuits
Worked example
A red LED needs a current of 20 mA, at which the potential difference across it is 2.0 V. Design a circuit to run it from a 9.0 V battery, choosing a series resistor from the standard values 220 Ω, 330 Ω, 390 Ω and 470 Ω. Find the power dissipated in the resistor, and comment on the design.
Step 1: Find the potential difference across the resistor
The LED and resistor are in series, so by Kirchhoff's voltage law their potential differences add to the supply.
Step 2: Find the ideal resistance
Step 3: Choose a standard value
330 Ω would allow , more than the LED should carry. Choose the next value up, 390 Ω.
Rounding up keeps the current at or below the LED's rating.
Step 4: Find the actual current
, assuming the LED's potential difference stays near 2.0 V.
Step 5: Find the power in the resistor
, comfortably below the 0.25 W rating of a standard resistor.
Step 6: Comment on efficiency
The LED itself uses only . About of the battery's energy becomes heat in the resistor, so a lower-voltage supply, such as two AA cells (3.0 V), would waste far less.
Answer
Use a 390 Ω resistor in series with the LED. The current is about 18 mA and the resistor dissipates about 0.13 W, so a standard 0.25 W resistor is fine. The design wastes about 78% of the battery's energy as heat, so a lower supply potential difference would be more efficient.
Try a similar one
A fresh question of the same kind, checked as you answer, with hints and a full solution.
Method
The series resistor takes the supply minus the LED's potential difference.
, then round up to a standard value.
Check the resistor's power against its rating.
Watch out for
Using the whole 9.0 V: ignores the LED's share.
Rounding down to 330 Ω, which lets more than the rated current flow.