Lesson 10: Moving conductors and AC generators
Energy in a rod sliding on rails
SkillsMoving conductors and generatorsFaraday's and Lenz's laws
Worked example
A metal rod long slides at a constant along two parallel rails joined at one end by a resistor. A uniform field points into the page, perpendicular to the plane of the rails.
(a) Calculate the EMF induced across the rod.
(b) Calculate the current.
(c) Calculate the force needed to keep the rod moving at constant speed, and show that the mechanical power supplied equals the electrical power.
Step 1: Find the rate of change of area
Each second the rod moves , sweeping out of extra loop area.
Step 2: Apply Faraday's law
This is the general result for a rod moving perpendicular to a field, derived from the formula book's Faraday's law with .
Step 3: Find the current
Step 4: Find the opposing force
The current in the rod feels . By Lenz's law this force opposes the motion, so you must push forward with to keep the speed constant.
Step 5: Compare the powers
Mechanical power: . Electrical power: . They are equal: every joule of work done pushing the rod becomes electrical energy, which the resistor turns into heat.
Answer
(a) (b) (c) ; both powers are .
Try a similar one
A fresh question of the same kind, checked as you answer, with hints and a full solution.
Method
EMF from the rate at which the loop's area (and so its flux) changes: .
Current from , then the opposing force from .
Check energy conservation by comparing Fv with VI.
Watch out for
Thinking no force is needed at constant speed. Without a push, the magnetic force on the induced current slows the rod down.