Lesson 6: Changes of state and specific latent heat
Measuring the latent heat of vaporisation
SkillsSpecific latent heatUncertainty and error
Worked example
A 500 W immersion heater keeps water boiling in an insulated beaker that stands on a digital balance. Once the water is boiling steadily, the balance reading falls by 50.0 g in 4.00 min.
(a) Estimate the specific latent heat of vaporisation of water from these results.
(b) Calculate the percentage error compared with the data book value.
(c) Explain why the experimental value is higher than the accepted value.
Step 1: Find the energy supplied
The heater power is energy per second, so multiply by the time in seconds.
Step 2: Find the mass that vaporised
The water lost from the beaker left as steam: .
Step 3: Rearrange
Step 4: Calculate the percentage error
Step 5: Explain the error
Not all 120 kJ went into vaporising water. Some was lost to the surroundings from the beaker and the steam, so less water boiled away than the energy supplied would suggest. Dividing by a too-small mass gives a too-large .
Answer
(a) (b) 6.2 % (c) energy lost to the surroundings means less water vaporised than expected, so is too large.
Try a similar one
A fresh question of the same kind, checked as you answer, with hints and a full solution.
Method
Energy from a heater: with in seconds.
Mass vaporised from the balance reading, in kg.
, then compare with the data book.
Watch out for
Using 4.00 instead of 240 s.
Measuring from the moment the heater is switched on, before the water boils, which adds the energy used to warm it.