Lesson 7: Heating curves and multi-stage problems
Reading c and L from a heating curve
SkillsHeating curves and multi-stage problemsSpecific heat experiments
Worked example
A 0.200 kg sample of a solid is heated by a 50.0 W heater. Assume all the heater's energy goes into the sample. The graph shows its temperature.
(a) State the melting point.
(b) Determine the specific heat capacity of the solid.
(c) Determine the specific latent heat of fusion.
(d) Is the specific heat capacity of the liquid greater or smaller than that of the solid? Justify using the graph.
Step 1: Read the melting point
The temperature stays constant at 80 °C between 300 s and 900 s while the solid melts. The melting point is 80 °C.
Step 2: Energy for the solid warming
From 0 s to 300 s the solid warms from 20 °C to 80 °C. and .
Step 3: Calculate c for the solid
Step 4: Calculate the latent heat
Melting lasts , so and .
Step 5: Compare the slopes
Solid: . Liquid: . With the same power and mass, the slope is , so the gentler slope means a larger . The liquid's specific heat capacity is greater (it works out to about ).
From , . Same and , so slope and are inversely related.
Answer
(a) 80 °C (b) (c) (d) greater, because the liquid section is less steep.
Try a similar one
A fresh question of the same kind, checked as you answer, with hints and a full solution.
Heating curve for the 0.200 kg sample with a 50.0 W heater.
Method
Flat section: over its duration, then .
Sloping section: , from the graph, then .
Compare slopes to compare specific heat capacities.
Watch out for
Reading times at the wrong ends of a section.
Using the temperature (80 °C) instead of the change (60 K).