Lesson 1: Yield, rate and the Haber process
Explain the conditions of the Haber process
SkillChoosing conditions for yield and rate
Worked example
Ammonia is made by the Haber process, , . Industrial plants operate at about and with an iron catalyst. Explain why these conditions are chosen.
Step 1: Identify the features of the reaction that matter
The forward reaction is exothermic (), and 4 mol of gas on the left form 2 mol on the right. It is reversible and reaches equilibrium.
Every argument about yield comes back to these two facts.
Step 2: Temperature and yield
By Le Châtelier's principle, a lower temperature favours the exothermic forward reaction, so a low temperature gives a higher equilibrium yield of ammonia.
Step 3: Temperature and rate
A lower temperature means fewer collisions with at least the activation energy, so the rate is slow and equilibrium takes too long to reach.
Step 4: State the temperature compromise
About gives an acceptable yield at an acceptable rate.
Step 5: Pressure
A high pressure shifts the equilibrium towards the side with fewer gas particles (the ammonia side), increasing the yield, and also increases the rate because the gases are more concentrated. Pressure is limited to about because higher pressures need costly compressors and thick-walled equipment, use more energy and increase the risk of a dangerous failure.
Step 6: Catalyst
The iron catalyst provides a pathway with a lower activation energy, so equilibrium is reached much faster. It does not change the equilibrium yield, but it lets the plant use a lower temperature, where the yield is higher, at a useful rate.
Answer
About balances the higher yield of a low temperature against the faster rate of a high one; about raises both yield and rate but is limited by cost and safety; the iron catalyst increases the rate without changing the yield, so a lower temperature is still fast enough.
Try a similar one
A fresh question of the same kind, checked as you answer, with hints and a full solution.
Method
Note whether the forward reaction is exo- or endothermic, and compare moles of gas on each side.
For each condition, give its effect on yield (Le Châtelier) and on rate (collision theory).
Explain the compromise, including cost and safety.
Say what the catalyst does and does not change.
Watch out for
Saying the catalyst increases the yield.
Explaining the rate with Le Châtelier's principle.
Saying high pressure is "too expensive" without giving the reason: compressors, equipment strength, energy, safety.