Lesson 8: Predicting redox reactions with E°
Identifying metals from measured cell voltages
SkillsPredicting redox reactionsGalvanic cellsElectrode potentials and E°cell
Worked example
A student builds three galvanic cells, each pairing a copper half-cell ( in ) with a half-cell of an unknown metal in a solution of its ion. In every cell the copper electrode is positive. The measured voltages are X: , Y: , Z: .
(a) Rank X, Y and Z as reducing agents.
(b) The student claims X is zinc. Evaluate the claim using the data book.
(c) Predict which electrode is the anode, and the approximate voltage, if the X and Z half-cells are joined.
Step 1: Interpret the signs
Copper is positive in every cell, so copper is the cathode and each unknown metal is oxidised at the anode. Each unknown is a stronger reducing agent than copper.
Step 2: Rank the reducing agents
The larger the voltage, the further the metal sits below copper in , so the stronger it is as a reducing agent: X > Y > Z.
, so a larger cell voltage means a lower for the metal.
Step 3: Estimate E° for X
. Zinc's is , which would give with copper.
Step 4: Evaluate the claim
The measured voltage is lower than predicted for zinc. Real cells usually read below , because of oxide on the electrode, concentrations and temperatures that are not exactly standard, and some loss to internal resistance. The nearest metals in the data book are zinc ( predicted) and iron (); is closer to zinc, and higher than iron could give even in ideal conditions. So the claim is reasonable, but not proved: a test such as whether X displaces iron from would support it.
Step 5: Join X and Z
X is the stronger reducing agent, so X is the anode (negative) and Z the cathode (positive). From the data, the voltage is about .
Both voltages were measured against the same copper half-cell, so the copper cancels out when you subtract.
Answer
(a) X > Y > Z. (b) X gives , closest to zinc (); the lower voltage is consistent with internal resistance and non-standard conditions, so the claim is plausible but needs another test. (c) X is the anode; about .
Try a similar one
A fresh question of the same kind, checked as you answer, with hints and a full solution.
Method
Use the sign of each electrode to decide which half-cell is reduced.
Turn each voltage into an estimate with .
Compare with the data book, allowing for measured values being lower than standard values.
Voltages measured against the same reference can be subtracted to predict a new cell.
Watch out for
Expecting measured voltages to match the data book exactly.
Adding the two voltages for the X–Z cell instead of subtracting them.