Lesson 8: Pressure, volume and temperature
A diver who holds their breath
SkillsPressure, volume and temperatureKinetic theory of gases
Worked example
At a depth of 20 m in the sea the total pressure is 300 kPa. A diver there fills their lungs with 6.0 L of air from their regulator and then, against their training, holds their breath while rising to the surface, where the pressure is 100 kPa.
(a) Calculate the volume the air in their lungs would occupy at the surface, assuming its temperature does not change.
(b) The water is 16 °C at 20 m and 24 °C at the surface. Determine whether including this temperature change makes the situation better or worse.
(c) Explain why divers are trained to breathe out continuously while ascending.
Step 1: Identify the relationship (a)
The amount of air is fixed and the temperature is assumed constant, so Boyle's law applies: .
Step 2: Calculate the volume at the surface
Step 3: Include the temperature change (b)
, . With :
Warming makes a gas expand at constant pressure, so the warmer water at the surface makes the expansion slightly worse.
Step 4: Interpret (c)
Lungs hold about 6 L at most, so air trying to occupy three times that volume would over-expand and tear the lung tissue (lung over-expansion injury) long before the diver reached the surface. Breathing out steadily lets the expanding air escape, keeping the lung volume safe. Most of the expansion happens near the surface: going from 20 m to 10 m only takes the pressure from 300 to 200 kPa, but going from 10 m to the surface halves it.
Answer
(a) 18 L. (b) Worse, but only slightly: about 18.5 L. (c) The air expands as the pressure falls (Boyle's law) and would over-expand the lungs; breathing out lets the extra volume escape.
Try a similar one
A fresh question of the same kind, checked as you answer, with hints and a full solution.
Method
Fixed amount and constant temperature: .
Include temperature with , in kelvin.
Link the numbers to the physical consequence.
Watch out for
Using gauge pressure (200 kPa from the water alone) instead of the total pressure (300 kPa).
Using °C in part (b): would claim the temperature effect is 50 %.