Lesson 10: Gas volumes and masses in chemical reactions
How much sodium azide fills an airbag?
SkillsGases in chemical reactionsUsing
Worked example
In some airbags, a spark sets off the rapid decomposition of sodium azide:
A driver's airbag must fill to 60.0 L with nitrogen at 125 kPa and 30 °C.
(a) Calculate the mass of sodium azide needed.
(b) The sodium produced is hazardous. Suggest why the airbag also contains potassium nitrate and silicon dioxide, and why an engineer would add slightly more sodium azide than calculated.
Step 1: Moles of nitrogen needed
.
Step 2: Mole ratio
2 mol gives 3 mol , so
Write the ratio as wanted over known: .
Step 3: Mass of sodium azide
, so
Step 4: Think about the real device (b)
Sodium is a reactive metal that reacts violently with water (including moisture in the air) to form corrosive sodium hydroxide. Potassium nitrate reacts with the sodium to make more nitrogen and metal oxides, and silicon dioxide turns those oxides into harmless glass. A little extra azide allows for the gas cooling as the bag fills, some gas escaping through the bag's vents, and the reaction not being perfectly complete.
Answer
(a) About 129 g of sodium azide. (b) To convert the reactive sodium into harmless products (and extra nitrogen); extra azide allows for incomplete reaction, gas loss and cooling.
Try a similar one
A fresh question of the same kind, checked as you answer, with hints and a full solution.
Method
for the gas at the stated conditions.
Mole ratio wanted ÷ known.
, then judge the answer against the real situation.
Watch out for
Using the ratio the wrong way round: gives 291 g.
Using 22.7 L mol⁻¹ even though the gas is at 125 kPa and 30 °C.