Lesson 5: Rays, sectors and combined regions
Sketch and , and find its area
SkillsRays, sectors and combined regionsCircles and discs
Worked example
Sketch the region and find its exact area.
Step 1: Sketch each condition
is the closed disc with centre and radius 3. is the sector between the rays at and , rays included, origin excluded.
Step 2: Shade the overlap
Both conditions hold in the slice of the disc between the two rays: a sector of radius 3 with angle . All its edges are included (solid), but the origin is not (open circle).
"" (and) means a point must satisfy both conditions, so only the overlap is shaded.
Step 3: Find the area
Area square units.
Leaving out the single point does not change the area.
Answer
is a quarter of the disc , between the rays at and (origin excluded). Its area is square units.
Try a similar one
A fresh question of the same kind, checked as you answer, with hints and a full solution.
Method
Sketch each condition on its own.
Shade only where all conditions hold.
Mark included boundaries solid and excluded points open.
Use the sector area formula .
Watch out for
Using the angle instead of the angle between the rays, .
Shading the whole disc or the whole sector rather than their overlap.