Lesson 10: Ray diagrams for mirrors and lenses
Locate an image with a convex lens ray diagram
SkillRay diagrams for mirrors and lenses
Worked example
An object tall stands from a convex lens of focal length . Use a ray diagram to determine the location, orientation and size of the image, and state whether it is real or virtual.
Step 1: Set up the diagram to scale
Draw the principal axis and the lens. Mark at and at on both sides. Draw the object tall at — beyond .
Step 2: Ray 1 — parallel, then through F
From the top of the object, draw a ray parallel to the axis to the lens, then through on the far side.
Step 3: Ray 2 — through the centre
Draw a ray from the top of the object straight through the optical centre, undeviated.
Step 4: Ray 3 — through F, then parallel
Draw a ray through on the object's side to the lens; it leaves parallel to the axis. (Two rays are enough; the third checks your drawing.)
Step 5: Read the image
The rays meet to the right of the lens, below the axis. The image is between and , inverted, tall (half the size: diminished), and real because the rays actually meet there.
Answer
The image is from the lens on the opposite side to the object (between and ). It is inverted, tall (diminished) and real.
Try a similar one
A fresh question of the same kind, checked as you answer, with hints and a full solution.
Drawn to scale: one unit is 1 cm. The three principal rays meet at the top of the image.
Method
Draw to scale and mark F and 2F on both sides.
Draw at least two principal rays from the top of the object.
Where the rays meet is the top of the image; measure its distance and height.
Describe: location, orientation, size, real or virtual.
Watch out for
Drawing the parallel ray through the F on the object's side.
Leaving out the size or the real/virtual description.