Lesson 3: Temperature, pH, concentration and inhibitors
Identify two inhibitors from rate data
SkillsFactors affecting enzyme activityAnalysing enzyme experiments
Worked example
The initial rate of an enzyme reaction (in of product per minute) was measured at different substrate concentrations, with no inhibitor, with inhibitor X and with inhibitor Y.
| Substrate concentration (mmol L⁻¹) | 1 | 2 | 5 | 10 | 20 | 40 |
|---|---|---|---|---|---|---|
| No inhibitor | 4.5 | 6.3 | 8.1 | 8.9 | 9.4 | 9.7 |
| Inhibitor X | 1.4 | 2.5 | 4.5 | 6.3 | 7.7 | 8.7 |
| Inhibitor Y | 2.3 | 3.1 | 4.0 | 4.5 | 4.7 | 4.9 |
(a) Calculate the percentage decrease in rate caused by inhibitor X at 1 and at 40 mmol L⁻¹. (b) Identify which inhibitor is competitive and which is non-competitive, and justify your answer with the data and a model of how each works.
Step 1: Percentage decrease for X at 1 mmol L⁻¹
, a decrease of about .
Step 2: Percentage decrease for X at 40 mmol L⁻¹
, a decrease of about .
Step 3: Look at Y the same way
Y roughly halves the rate at every concentration: against at the lowest, against at the highest (about a decrease each time). Its maximum rate is about , half the uninhibited maximum.
Step 4: Identify and justify X
X's effect shrinks from to as the substrate concentration rises, and its rate approaches the uninhibited maximum. Substrate molecules outcompete it, so X must bind the active site: X is competitive.
Step 5: Identify and justify Y
Y's effect does not shrink with more substrate, and the maximum rate stays at about half. Y must bind elsewhere (an allosteric site) and change the shape of the active site, which substrate cannot undo: Y is non-competitive.
Justify with the evidence (numbers from the table) and the mechanism (where the inhibitor binds).
Answer
(a) About 69 % at 1 mmol L⁻¹ and 10 % at 40 mmol L⁻¹. (b) X is competitive: its effect is overcome by more substrate, so it competes for the active site. Y is non-competitive: it halves the rate at every concentration and lowers the maximum, so it binds an allosteric site and changes the active site.
Try a similar one
A fresh question of the same kind, checked as you answer, with hints and a full solution.
Method
Compare each inhibitor's effect at low and high substrate concentration.
Effect overcome by more substrate → competitive (active site).
Effect unchanged and maximum rate lowered → non-competitive (allosteric site).
Watch out for
Saying Y is more effective "because it is non-competitive" without using the data.
Calculating the percentage of the inhibited rate instead of the uninhibited one.