Lesson 5: Combining the rules and factorised form
When does a car's suspension first come to rest?
SkillsCombining the rulesRates of change in periodic modelsSimplest and factorised form
Worked example
After a car hits a bump, the vertical displacement of its body from the rest position is modelled by
centimetres, where is the time in seconds after the bump.
(a) Show that the velocity of the car body is cm/s.
(b) Find the first time after the bump when the car body is momentarily at rest, correct to two decimal places.
(c) Find the displacement at that time, and explain what it shows about the suspension.
Step 1: (a) Differentiate with the product rule
, ; , .
Velocity is the rate of change of displacement, . Both factors need the chain rule.
Step 2: (a) Factorise
Take out : , as required.
Step 3: (b) Set the velocity to zero
for every , so only when
The factorised form shows the exponential factor can never be zero, so only the bracket matters. Dividing by is fine because would make and the bracket .
Step 4: (b) Find the first positive solution
in the second quadrant, so the smallest positive solution is
The calculator gives , which is negative, so add to reach the next solution.
Step 5: (c) Evaluate and interpret
cm.
The body has swung past the rest position to 2.35 cm below it before turning back, less than half the original 5 cm: the suspension is damping the oscillation.
Answer
(a) Shown above. (b) s. (c) cm: the body is 2.35 cm below its rest position when it turns, and the oscillation has shrunk to less than half its initial size.
Try a similar one
A fresh question of the same kind, checked as you answer, with hints and a full solution.
Method
Differentiate the model with the product and chain rules, then factorise.
Use the factorised form: an exponential factor is never zero.
Solve the remaining trigonometric equation in radians and pick the solution the question asks for.
Substitute back into the original model and interpret in context.
Watch out for
Taking : that time is before the bump.
Leaving the calculator in degree mode.