Lesson 4: The action potential
Interpret an action potential trace
SkillAction potentials
Worked example
The graph shows the membrane potential of a squid axon recorded during one action potential.
(a) State the resting potential. (b) Calculate the amplitude of the action potential, measured from the resting potential to the peak. (c) Estimate how long the membrane potential is above the resting potential. (d) Explain the change in membrane potential between 1.9 ms and 3.0 ms.
Step 1: Read the resting potential
Before the stimulus, the trace is flat at .
Step 2: Calculate the amplitude
The peak is , so the amplitude is .
Subtracting a negative number adds its size. A common slip is .
Step 3: Estimate the duration
The potential leaves the resting level at about and falls back through it at about , so it is above rest for about .
Step 4: Explain the fall from 1.9 to 3.0 ms
At the peak the voltage-gated channels close and voltage-gated channels open. diffuses out of the axon, down its concentration gradient, so the inside becomes negative again (repolarisation). The channels are slow to close, so too much leaves and the potential overshoots to , below the resting potential (hyperpolarisation).
Answer
(a) . (b) . (c) About . (d) Na⁺ channels close and K⁺ channels open; K⁺ diffuses out (repolarisation), and because the K⁺ channels close slowly the membrane briefly hyperpolarises to −75 mV.
Try a similar one
A fresh question of the same kind, checked as you answer, with hints and a full solution.
Membrane potential of an axon during one action potential.
Method
Read the flat part of the trace for the resting potential.
Amplitude = peak − resting potential (watch the signs).
Rising: Na⁺ in. Falling: K⁺ out. Below rest: K⁺ channels slow to close.
Watch out for
Saying K⁺ is pumped out during repolarisation. It diffuses out through channels.
Measuring the amplitude from 0 mV instead of from the resting potential.